Table of Contents
Advertisement
AIR/FUEL, EXHAUST AND EMISSION CONTROL SYSTEMS
9
1. Cover bolt
2. Air filter cover
3. Air filter
4. Screw
5. Surge tank
6. Gasket
7. Bolt
8. Collar
9. Damper
10. Intake duct
leaks. If there is a leak, solve the problem be-
fore installing the fuel tank.
AIR FILTER HOUSING
NOTE
Air filter service is described in Chap
ter Three.
AIR INTAKE
11. Surge tank base
12. Air filter housing
13. Air filter housing duct
14. Bolt
15. Washer
16. Air filter housing
bracket (upper)
17. Clamp
18. Surge tank duct
19. Damper
Removal/Installation
Refer to Figure 9.
1. Securely support the motorcycle on level
ground.
2. Remove the fuel tank as described in this chap-
ter.
20. Air filter housing
bracket (lower)
21. Cylinder head
breather hose
22. Carburetor breather
hose
23. Drain
24. Plug
25 Rear cover
207
8
- Quick Links:
- Carburetor Specifications
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the V star 1100 and is the answer not in the manual?
Questions and answers
How can I download this manual in Polish?
Diagnostic port location for a 04 v-star 1100
Why is my starter clutch turning the wrong way
When I press my clutch in starterturns on but with my kill switch on. Why
The Yamaha V Star 1100 has an ignition circuit cut-off system integrated into the clutch lever holder. This system ensures that the starter motor will only engage if the clutch is pulled in, preventing accidental starts in gear. Additionally, the engine stop (kill) switch must be in the correct position to complete the ignition circuit. If the clutch is disengaged or the kill switch is off, the circuit remains open, preventing the starter from operating.
This answer is automatically generated
I need to see diagrams and directions on the wiring system from front to back for a 1100 hyú
The Yamaha V Star 1100 wiring diagrams and directions are available toward the back of the repair manual. The diagrams show wire routing and connections for systems such as:
- Headlight, tail light, high beam indicator, meter illumination
- Front turn signals and position lights
- Main switch, dimmer switch, and pass switch
- Brake light and switches
- Horn circuit
To rewire the motorcycle from front to back:
1. Check the manual for the full wiring diagram.
2. Use the diagram to identify wire colors and connection points.
3. Inspect and test continuity of:
- Headlight and socket
- Turn signal bulbs and sockets
- Brake light bulbs and switches
- Fuses (main, signal, and headlight)
- Connectors and switches (main, dimmer, pass)
4. Restore wires using proper tools to crimp and match colors based on the diagram.
The repair manual is the main source for accurate wire locations and functions.
This answer is automatically generated
I had my bike running no problem, once i turned it off and try to start it back up this is what happens. When i try to start my bike it just clicks. battery is good, fuses are good!