Table of Contents
Advertisement
288
15
is still centered within the bearing, install the
axle partway through the hub and center the
spacer. Remove the axle and continue install-
ing the bearing until it bottoms.
5. Reassemble the hub as described in this chapter.
FRONT WHEEL
Refer to Figure 15.
FRONT WHEEL
Removal
1. Securely support the motorcycle with the front
wheel off the ground.
2. Test the wheel bearings as follows:
a. Hold the wheel along its side (hands 180°
apart), and try to rock it back and forth. If
there is any play at the axle, the wheel bear-
ings are worn or damaged.
b. Have an assistant apply the brake while you
rock the wheel again. On wheels with se-
CHAPTER TEN
1. Front axle
2. Axle clamp bolt
3. Collar
4. Seal
5. Bearing
6. Front wheel
7. Distance collar
8. Hub plate
9. Brake disc bolt
- Quick Links:
- Carburetor Specifications
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the V star 1100 and is the answer not in the manual?
Questions and answers
How can I download this manual in Polish?
Diagnostic port location for a 04 v-star 1100
Why is my starter clutch turning the wrong way
When I press my clutch in starterturns on but with my kill switch on. Why
The Yamaha V Star 1100 has an ignition circuit cut-off system integrated into the clutch lever holder. This system ensures that the starter motor will only engage if the clutch is pulled in, preventing accidental starts in gear. Additionally, the engine stop (kill) switch must be in the correct position to complete the ignition circuit. If the clutch is disengaged or the kill switch is off, the circuit remains open, preventing the starter from operating.
This answer is automatically generated
I need to see diagrams and directions on the wiring system from front to back for a 1100 hyú
The Yamaha V Star 1100 wiring diagrams and directions are available toward the back of the repair manual. The diagrams show wire routing and connections for systems such as:
- Headlight, tail light, high beam indicator, meter illumination
- Front turn signals and position lights
- Main switch, dimmer switch, and pass switch
- Brake light and switches
- Horn circuit
To rewire the motorcycle from front to back:
1. Check the manual for the full wiring diagram.
2. Use the diagram to identify wire colors and connection points.
3. Inspect and test continuity of:
- Headlight and socket
- Turn signal bulbs and sockets
- Brake light bulbs and switches
- Fuses (main, signal, and headlight)
- Connectors and switches (main, dimmer, pass)
4. Restore wires using proper tools to crimp and match colors based on the diagram.
The repair manual is the main source for accurate wire locations and functions.
This answer is automatically generated
I had my bike running no problem, once i turned it off and try to start it back up this is what happens. When i try to start my bike it just clicks. battery is good, fuses are good!