Sharp IV-S30J User Manual page 231

Setting the Input/Output Conditions
THRESHOLD VAL
Specify the threshold value for binary conversion.
Select this line and press the SET key. The
"THRESHOLD VAL" setting screen will appear.
For details, see pages 3-10.
INVERT B/W
NO Do not reverse black and white areas.
The area detected by binary
YES
conversion will be displayed as white.
(2) When "GRAY-SRC" is selected on the "
CCD START" line.
REF-IMG AREA
SEARCH AREA
DETECT CRD
CONTR. PIXEL
MATCH LEVEL
Specify the range for the degree of match
While "
SET key. The five digits for the lower limit will be
highlighted. Change the number using the up and
down arrow keys.
To change the value of individual digits, press the
SET key again. The cursor will move to the left
most digit. Adjust the value of each digit using the
up/down/left/right arrow keys.
When the value is correct, press the SET key. All
five digits will be highlighted again.
Then, press the left or right arrow key to move the cursor to the next five digits, which are the upper
limit. Adjust this number the same way.
(3) When "EDGE DTECT" is selected on the "
CCD START" line.
SEARCH AREA
DTECT MODE
SEARCH DIRECT
THRESHOLD VAL
16
For details, see
pages 5-5 to 5-7.
MATCH LEVEL" is selected, press the
For details, see
pages 11-7 to 11-9.
THRESHOLD VAL AUTO-REG RESET
1U.LM
2L.LM
SET=CHNG ESC=BACK SEL=CHNG IMG TRG=FUNC
TRIG CCD TRIG COND SCREEN SAVE
1REF-IMG AREA
2SEARCH AREA
3DIRECT CRD
4CONTR.PIXEL
5MATCH LEVEL
SEL=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=FUNC
TRIG
CCD TRIG COND
1SEARCH AREA
2DTECT MODE
3SEARCH DIRECT
4THRESHOLD VAL
SEL=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=FUNC
16-20
F C1 BRT
050 0 255
100 1 255
SET (224.208) (287.271)
SET (216.200) (295.279)
CENTER (255.239)
3
+07000~+10000
SCREEN SAVE
SET (224.208) (287.271)
CHNG POINT
HORIZ (
SET (D:050 E:2 F:04)
F C1 BRT
F C1 BRT