Sharp IV-S30J User Manual page 150

Existence Inspection by Point Measurement
The "EVALUAT COND"(evaluation conditions) screen will appear.
For details about the evaluation conditions, see page 3-17.
When MODE has been set to "BINARY"
EVALUAT COND SCREEN COND SAVE EDIT SEL
1PAGE CHNG
2P000
3P001
4P002
5P003
6P004
7P005
8P006
9P007
0TEST
When MODE has been set to AVG-GRAYS
EVALUAT COND SCREEN COND SAVE EDIT SEL
PAGE CHNG
CONDITION SET REST(+10%)
P000
P001
P002
P003
P004
P005
10
P006
P007
TEST
Numeric calculation setting
- Press the TRG/BRT key to move the cursor to the upper function menu, and highlight "COND" using
the left and right arrow keys. Press the SET key to show the popup menu. Select "NUM-CALC" from
the popup menu.
- Select "NUM-CALC" on the menu tree.
See "Chapter 14: Numerical calculation."
Output condition setting
- Press the TRG/BRT key to move the cursor to the upper function menu, and highlight "COND" using
the left and right arrow keys. Press the SET key to display the popup menu. Select "OUT" from the
popup menu.
- Select "OUT-COND" on the menu tree.
See "Chapter 16: Setting the Input/Output Conditions."
˚ [TEST RESULT]
WHITE OK
WHITE OK
WHITE OK
WHITE OK
WHITE OK
EXEC (WITH-POSI.ADJ WITHOUT-POSI.ADJ)
[TEST RESULT]
200~210 200
200~210 200
200~210 200
200~210 200
200~210 200
EXEC(WITH-POSI.ADJ WITHOUT-POSI.ADJ)
Acceptance (OK/NG) criteria
WHITE: Acceptable when a majority of the inspected
pixels are white.
BLACK: Acceptable when a majority of the inspected
pixels are black.
F C1 DRK
Ex.: When the point to be inspected is 8 X 8 (64 pixels)
[OUTPUT]
and WHITE is specified, if 33 white pixels are
NO
detected, the point is accepted.
NO
NO
You can set the output destinations using the up
NO
and down keys. (NO, Y0 to Y7, C000 to C127)
NO
Not displayed for unregistered point numbers.
Average light level for each point
F C1 DRK
[OUTPUT]
OK NO
OK NO
You can set the output destinations using the up
OK NO
and down keys. (NO, Y0 to Y7, C000 to C127)
OK NO
OK NO
Average light level for each point
10-8