Yamaha DME64N Owner's Manual page 458

Chapter 6 Component Guide
MY16-CII
Double click to open the component editor.
1
2
3
4
5
6
7
* Select "Disable" if you intend to make settings via the CobraNet network using the CobraNet Manager, for example. In such
cases selecting "Enable" may result in incorrect settings.
NOTE
Refer to the "MY16-CII Owner's Manual" or "CobraNet Manager Lite for YAMAHA Owner's Manual" for mote information on
CobraNet.
458 DME Designer Owner's Manual
1
2
3
4
5
6
Section Name/Parameter
Setting from this Window
High Sampling Input Format
Mode
Double FS
Output Format
Bundle Input
Number
Output
Serial Rx
Channel
Tx
Properties Bit Length
Latency
Advanced
Range
Disable/Enable When "Disable" is selected settings
made via the CobraNet network take
priority. When "Enable" is selected
settings made from the DME Designer
take priority.*
Double Channel Selects the format for 88.2/96 kHz
Single sampling rates.
Linked to Output Format.
ON/OFF When turned ON the speed of the MY
card word clock output is doubled. Only
available when the card is set as the
word clock master.
Double Channel Selects the format for 88.2/96 kHz
Single sampling rates.
Linked to Input Format.
0 ~ 65279 Specifies the input bundle number.
0 ~ 65279 Specifies the output bundle number.
OFF, 1 ~ 15 Specifies the serial receive channel.
OFF, 1 ~ 5 Specifies the serial transmit channel.
Bit Off Specifies the output bit rate.
16bit Output is muted when "Bit Off" is
20bit selected.
24bit
5.33ms Specifies the latency.
2.67ms
1.33ms
- Opens the "Advanced Settings"
Window. Refer to "Advanced Settings"
Window on
Function
for details.
page 453