Chapter 5 Components
Knob
Drag to adjust the parameter.
You can change the way knobs operate, using the [Component Editor] tab
in the "Preferences" dialog box.
"Preferences" dialog box
NOTE
To make a finer setting, press the <Shift> key while dragging the knob when [Knob Mode] is "Linear".
If you click a knob while pressing the <Ctrl> key, the setting will return to its default value.
Slider
You can change the parameter by dragging the slider.
You can set the action that results from using the mouse on the scale area with [Component Editor]
tab
"Preferences" dialog box
NOTE
To make a finer setting, press the <Shift> key while dragging the slider.
If you click a slider while pressing the <Ctrl> key, the setting will return to its default value.
296
DME Designer Owner's Manual
"Component Editor" tab
(page
[Slider Mode] in the "Preferences" dialog box.
63)
Slider
Scale
"Component Editor" tab
(page
[Knob Mode] setting
63)