Input/Output Terminal On Rear Panel; Specifying A Vmd Event; Specifying Timer Events - JVC VR-N1600U - 16 Channel Network Video Recorder Instructions Manual

Input/Output Terminal on Rear Panel

● The VR-N1600U/E unit acts as a network encoder (IP
video server) in the system and the device name assigned
to it is NVR .
● The input/output terminals on the rear panel have been
assigned to the NVR device by default.
Input Terminals
Input Name of Input
Terminal Event
Name
Alarm IN 1 to 8
Rising
ALARM IN 1
to 8
Alarm IN 1 to 8
Falling
Output Terminals
Output Name of Output
Terminal Event
Name
Set output
Option Out 1,2
high
OPTION
OUT1,2
Set output
Option Out 1,2
low
Note :
● The output duration of the rear output terminals is
indicated as 0 seconds in the output information. In actual
fact, output continues indefinitely.
● Output events of the rear output terminals cannot be
deleted.
● All terminal inputs are treated as alerts, but only one
terminal can be associated (Sequence) with recording
start.

Specifying a VMD Event

1
Select the camera for specifying the VMD event
from the [Defined events] list on the [I/O Setup]
screen
2
Click the [Add VMD Event(motion Detection)]
button
If a multi-camera device is selected, such as a network
encoder (IP video server), a dialog for you to select the
required camera will appear.
Note :
● The [Add VMD Event(motion Detection)] button is
disabled if there is no VMD event available for the network
camera.
Event Description
Event during detection of
Make signal input
Even during detection of
Break signal input
Output Action
Outputs the Make status
Outputs the Break status

Specifying Timer Events

Timer event can be attached to a special event.
Timer event will be triggled according to the specified
duration after the occurance of the related event.
1
Select the event for adding a timer event from
the [Defined events] list on the [I/O Setup]
screen(An example of when attaching to input
event)
[I/O Setup] Screen
2
Click the [Add new event...] button
● The [New Timer] screen appears.
[New Timer] Screen
3
Specify the timer interval and timer event name.
Item
A
Timer event is Displays the event or event button
name for which a timer event is
started by:
added. (This is a read-only field.)
B
Timer event For specifying a name for the timer
event.
name
Memo :
● Event names must not contain the
C
Timer event For specifying the time interval from
the occurrence of the event or
occurs after:
clicking of the event button until the
timer event is triggered. Specify the
time interval in seconds or minutes.
A
B
C
Description
following characters: < > & ' " \ / : * ?
| [ ].