Smart Search - JVC VR-N1600U - 16 Channel Network Video Recorder Instructions Manual

Basic Operation
Playing Back Recorded
Images via Mouse Control
(continued)

Smart Search

Smart Search enables you to search the parts with motion by
specifying the search area within the recorded images of the
selected camera.
1
Double-click the [Smart Search] bar on the
[Browse] screen
5
6
2
2
Tick [Show Grid] in [Search Area] setting
3
Select the camera to display
● A blue grid overlay appears.
4
Click and drag within the screen to specify the
search area.
● The areas that you have selected become transparent.
● Select the [Include] check box to add the area selected
by dragging to the search area. Select the [Exclude]
check box to remove the area selected by dragging
from the search area.
● Click the [Invert] button to reverse the area selection.
NVR Viewer
4
[Browse] Screen
7,8
5
Select the sensitivity level from the [Sensitivity]
list in [Search Setup]
● The setting values are as follows.
●[Very High]
●[High]
●[Medium]
●[Low]
●[Very Low]
6
Set the time interval in the [Interval] list
7
Press the [Previous] or [Next] button to search
through data for which motion has been
detected within the area
● Smart Search begins. When motion is detected inside
the selected area, it will be highlighted in the view.
Note :
● Smart Search is carried out in the [forward] and
[backward] directions from the time of the image you are
viewing.
● Smart Search that is performed during recording may
lower the recording frame rate. Check the performance
meter while adjusting the playback speed to ensure that
the display does not turn red.
8
To continue searching, click the [Previous] and
[Next] buttons
Memo :
● You can use the [Save] button to temporarily save the area
that you have selected in Step 4.
To return to the saved area settings, click the [Load]
button after selecting another area.
● To cancel the area selection, tick [Exclude] and drag all
the areas.