Table of Contents
Advertisement
When you select Recovers both C: and D: drive, the recovery process will
delete the recovery data installed in the hard disk. Therefore you will not
be able to recover your system from the hard disk.
When you select Recovers both C: and D: drive, reinstall the INSTANT
PLAY after completing the recovering process.
10. Read the message and select Continue; then, press Enter. Follow the on-screen
instructions for replacing the recovery CDs.
Although the pointer may be shown on the screen, never touch the
keyboard, touchpad or screen during recovery except when the message
prompts you to. If you touch them, the re-installation will be canceled.
11. After the recovery process is complete, the system will restart automatically.
When the message Press F2 for System Utilities appears, press F2. The Setup
Utility will open.
12. In the Exit menu, select Load Setup Defaults; then, press Enter twice.
13. In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter
twice. The system will restart.
14. Set up Windows, following the instructions on the screen. Make sure to remove
the disc and set date and time.
15. If the entire system (both C: and D: drives) has been recovered, go to the
Reinstalling INSTANT PLAY section below.
Reinstalling INSTANT PLAY
After recovering both C: and D: drives, follow these steps to reinstall INSTANT
PLAY.
1.
Restart the computer and press F2 when the message Press F2 for System
Utilities appears. The Setup Utility will open.
2.
Insert the "INSTANT PLAY INSTALLATION CD-ROM" into the optical
drive.
3.
In the Exit menu, select Load Setup Defaults; then, press Enter twice.
4.
In the Boot Sequence of the Boot menu, set the CD-ROM Drive to the top of the
list; then, press Esc.
A-23
Advertisement
Table of Contents
