Canon Arizona 6100 XTHF Mark II Series User Manual page 91

The media registration pins behaviors include:
• Off
• Independent of vacuum (manual)
• Linked to vacuum, Zone A only (both groups - vertical and horizontal);
• Linked to vacuum, Zone B only (both groups - vertical and horizontal);
• Linked to vacuum, Full table mode (both groups in Zone A + vertical in Zone B);
• Linked to vacuum, Zone A and B - 2 up mode (both groups in either Zone A or Zone B).
Enable/Disable Registration Pins
Each registration pin can be configured as active or not available. By default all pins are active as
shown by the check mark associated with each pin. Click on a registration pin check box to
disable that pin. The check mark will disappear. Click the box again to enable the pin and the
check mark will appear to confirm that pin is active again.
Media Loading and Registration
Loading media on to the vacuum table is a manual process. A configurable automated pin
registration system is provided to facilitate the loading process. Pin positions support both 2-up
and large format single sheet printing. In addition, the following prints are provided to help with
positioning of the media. They can be printed directly on to the table to show the following:
• 2.5m Ruler Print-1mm Resolution-Primary Origin (Horizontal Axis)
• 2.5m Ruler Print-1 mm Resolution-Secondary Origin (Horizontal Axis)
• 3.2m Ruler Print-1mm Resolution (Vertical Axis)
• 98inch Ruler Print-0.125inch Resolution-Primary Origin (Horizontal Axis)
• 98inch Ruler Print-0.125inch Resolution-Secondary Origin (Horizontal Axis)
• 126inch Ruler Print-0.125inch Resolution (Vertical Axis)
Media Registration
Chapter 4 - Operating the Printer 91