Canon PIXMA iP6220D Series Quick Start Manual page 111

II
Cannot Print Properly from the Digital Camera
The following are the possible errors that may occur when printing directly from
a digital still camera or digital video camcorder*, and the countermeasures to eliminate
them.
*Hereafter, the digital still camera and digital video camcorder are collectively called
a digital camera or camera.
WNote
This section describes errors that are indicated on Canon-brand PictBridge- or
Bubble Jet Direct-compatible cameras.
The error messages and operations may vary depending on the camera you are
using. If you cannot clear the error on your device, check the error message
displayed on the LCD of the printer, and then clear it. For details, see "An Error
Message is Displayed on the LCD" on page
58.
Error message on camera
I
Try This
Printer in use/Printer warming up
No paper
Paper jam
Paper lever error
Printer cover open
No printhead
Waste tank (ink absorber*2) full
Images are being printed from the computer. Wait until printing ends. The printer
automatically starts printing the images from the camera after completing the current
printing. If the printer is warning up, wait until warm-up ends. When it is ready,
the printer starts printing automatically.
Load paper in the auto sheet feeder, and select Continue*l in the display on your
camera.
Select Stop in the display on your camera to stop printing.
Remove the jammed paper, load new paper, and press the OK button on the printer and
retry printing.
Set the paper thickness lever to the left position.
If the paper is scratched even when printing on plain paper, set the paper thickness
lever to the right position.
Return the paper thickness lever to the left after printing.
Close the front cover on the printer.
Possible causes are as follows:
• The FINE Cartridge may not be installed properly.
• The FINE Cartridge may not be the compatible with this printer.
Install the appropriate FINE Cartridge. If lines are misaligned or the resulting output
is not satisfactory, carry out the print head alignment.
• Some FINE Cartridge are not installed in place.
Install the FINE Cartridge in the appropriate positions.
The printer has a built-in waste ink absorber to hold the ink used during print head
cleaning, for example.
You can continue printing for a while by selecting Continue*l in the display on your
camera.
However, because printing is disabled once the waste ink absorber becomes
completely full and until the waste ink tank is replaced, you are recommended to
contact the Customer Care Center as early as possible. (You will need to replace
a particular part of the printer.)
65