Mitsubishi Electric MELSEC iQ-R Series User Manual page 31

Access by specifying the network number and the station number of a target station
A target device can be accessed via a relay station when the target device is connected within eight networks from a station,
on which an MES interface module is mounted, and can be identified by the network number and the station number (or CPU
number).
: Accessible, : No combination
Access route
CC-Link IE Controller Network
CC-Link IE Field Network
MELSECNET/H network
*4
Ethernet
*1 It can access to an RnENCPU only in a single CPU system.
*2 No combination with the MELSECNET/H network for process CPUs and safety CPUs
*3 Can be accessed only when using an RD81MES96N.
*4 It is also supported by a QCPU (Q mode) for which the MELSOFT connection extended setting was set.
Access by specifying the start I/O number of a module to be routed and the station number of
a target station
The following table shows the accessible routes to connect with a target device and a station on which an MES interface
module is mounted directly.
: Accessible, : No combination
Access route
CC-Link
*1 It can access to an RnENCPU only in a single CPU system.
*2 Can be accessed only when using an RD81MES96N.
Access target device type (series)
RCPU QCPU (Q mode)
Program C Program
mable Controller mable
controller module controller
CPU/ CPU/
Process Process
CPU/ CPU
Safety
CPU
*1*2
  
(CPU No.1 (CPU No.1 (CPU No.1
to 4) to 4) to 4)

Access target device type (series)
RCPU QCPU (Q mode)
Program C Program
mable Controller mable
controller module controller
CPU/ CPU/
Process Process
CPU/ CPU
Safety
CPU
*1
  
(CPU No.1 (CPU No.1 (CPU No.1
to 4) to 4) to 4)
LCPU FX5CPU
C Program
Controller mable
module controller
CPU
  
(CPU No.1
*3
 
to 4)
 
 
LCPU FX5CPU
C Program
Controller mable
module controller
CPU
*2
  
(CPU No.1
to 4)
2 SPECIFICATIONS
2.2 Access Specifications for a CPU Module
2
FXCPU

FXCPU

29