Connectable Devices - Mitsubishi Electric MELSEC iQ-R Series User Manual

5.2

Connectable Devices

This section shows the connectable devices to an MES interface module.
SD memory card (sold separately, required)
One SD memory card is required for using an MES interface module.
Use one of the following SD memory cards manufactured by Mitsubishi Electric.
Model name
NZ1MEM-2GBSD
NZ1MEM-4GBSD
NZ1MEM-8GBSD
NZ1MEM-16GBSD
When using an SD memory card, make sure to refer to the following: (Page 70 Considerations for using an SD memory
card)
Ethernet (twisted pair) cable (sold separately)
The Ethernet cables compliant with IEEE802.3 1000BASE-T/100BASE-TX/10BASE-T standards can be used.
Transmission speed
1 Gbps
100 Mbps
10 Mbps
When using an Ethernet cable, make sure to refer to the following: (Page 82 Wiring Precautions)
Unshielded twisted pair cable (UTP cable)
Shielded twisted pair cable (STP cable)
Straight cable
Category 5e or higher
Category 5 or higher
Category 3 or higher
Capacity
2 GB
4 GB
8 GB
16 GB
Crossover cable
Category 5e
Category 5 or 5e
Category 3 to 5e
5 SYSTEM CONFIGURATION
5.2 Connectable Devices
5
75