Huawei DBS3900 Installation Manual page 69

DBS3900 (Ver.B)
Installation Guide
Table 6-3 SLPU-related cables
Cable
Surge protection
transfer cable for
monitoring signals
External dry-contact
monitoring signal
cable
Procedure
Step 1 Install cable racks on both sides of the SLPU and ensure that the mounting ears are on the same
plane as the SLPU panel, as shown in
Figure 6-43 Installing cable racks
Step 2 Slide the SLPU into the cabinet, and then use the screwdriver to tighten the two screws on the
mounting ears of the SLPU, as shown in
Issue 06 (2011-09-15)
6 Outdoor Scenario with AC Power Supply (BBU Installed
One End
RJ45 connector
Bare wire
Figure
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
The Other End
RJ45 connector
Depending on the
external equipment
6-43.
Figure 6-44.
in an APM30H)
Remarks
Grey shielded
straight-through
cable
-
56