ABB TZIDC Manual page 30

30 TZIDC DIGITAL POSITIONER | DS/TZIDC-EN REV. G
—
... Use in potentially explosive atmospheres
... IECEx
Type of protection Ex e – increased safety, Ex n – non-
sparking
Ex marking
IECEx Ex ec
Marking Ex ec IIC T6 resp. T4...T1 Gc
Type Examination Test
IECEx TUN 04.0015X
Certificate
Type Increased safety
Standards IEC 60079-0, IEC 60079-7
IECEx Ex nA
Marking Ex nA IIC T6 resp. T4...T1 Gc
Type Examination Test
IECEx TUN 04.0015X
Certificate
Type IP rating 'n'
Standards IEC 60079-0, IEC 60079-15
Temperature Data
Temperature class
T4 to T1
T6*
* When using the 'Plug-in module for digital feedback' in temperature
class T6, the maximum permissible ambient temperature range is
−35 to +35 °C.
Special conditions
• For the 'Feedback on the actuator position using
proximity switches (Pepperl & Fuchs SJ2-SN)' circuit,
measures outside of the device must be implemented to
prevent an up-scale of the rated voltage by more than
40% in the event of transient disturbances.
• Only devices that are suited for operation in hazardous
areas of Zone 2 and the conditions prevailing at the place
of use may be connected to circuits in Zone 2
(manufacturer's declaration or certificate from the test
center).
• It is only permissible to connect, disconnect, and switch
live circuits during installation or maintenance, or for the
purpose of carrying out repairs.
Note
It is considered very unlikely that a potentially hazardous
atmosphere would be present in Zone 2 at the same time
that installation or maintenance or repair work was being
carried out.
• Only non-flammable gases must be used for pneumatic
power supply.
• Only use suited cable entries that meet the requirements
of EN 60079-7 or EN 60079-15.
Electrical Data
In the 'Increased safety Ex ec or non-sparking Ex nA' type of
protection only for connection to a certified intrinsically safe
circuit.
Current circuit (terminal) Electrical information (maximum values)
Signal circuit
(+11 / -12)
Contact input
(+81 / -82)
Switch output
(+83 / -84)
Local communication
interface (LCI)
The following modules may be operated as an option:
Current circuit (terminal) Electrical information (maximum values)
Feedback on the
actuator position using
Ambient temperature Ta
proximity switches,
−35 to +85 °C
(Pepperl & Fuchs SJ2-SN)
−35 to +50 °C*
(Limit1: +51 / −52),
(Limit2: +41 / -42)
Plug-in module for
digital feedback
(+51 / -52)
(+41 / -42)
Plug-in module for
analog feedback
(+31 / -32)
U = 9.7 V DC
I = 4 to 20 mA, max. 21.5 mA
U = 12 to 24 V DC
I = 4 mA
U = 11 V DC
Only for connection to a programming device
using an ABB LCI adapter (Um ≤ 30 V DC)
outside the hazardous area.
U = 8.2 V (Ri approx. 1 kΩ)
U = 5 to 11 V DC
U = 10 to 30 V DC
I = 4 to 20 mA, max. 21.5 mA