Table 5 Led Indicators On Control Panel (Cp) - Panasonic Brooks FireTracker FT1020G3 Operation Manual

P9 Several Alarms
3.4.1.2 FT1020G3 Display CP Indicators

Table 5 LED indicators on Control Panel (CP)

No. LED Indicator
L7 System fault
L8 Test mode
Fault / Disablements
L9 General fault
General
L10
disablements
L11 Alarm devices
L12 Fire brigade TX
ASE (routing equipment)
Fault TX
L13
activated
Fire brigade TX
L14
delay
Note: Acknowledged alarm and isolated alarm are used only in the NZ convention.
10
The soft key "P8" has the function Alert Annunciation Acknowledge, if a COM loop unit is configured for alert annunciation.
11 Serviced fault will clear if the fault is set to non-latching in the system properties
12 Serviced fault will clear if the fault is set to non-latching in the system properties
13 Main board 5012 Terminal Block "J3:3-4", fuse F8 (T500mA 250 V – 5 x 20mm Ceramic).
14 See also chapter "Fault acknowledge"
the key in the display, the key has no function
Used when LEDs "Several Alarms" (L6) are lit, scroll
through the queued alarm points or zone-addresses. For
Grey more details, see chapter "Fire alarm" page 58.
Note: To scroll/browse through the queued zones, use
the soft key "Next zone" (P5).
Colour Indicating
FT1020G3 is not running due to one of the following:
• S/W fault
• CPU fault
Yellow
• Memory fault
• No contact between main board and MMI board
• FDCIE restart (fault code ≠ 00 / 03 / 25 / 50 / 53)
One or more zones are in "test mode", see page 110 &
Yellow
148.
Fault(s) in the system, i.e. not acknowledged fault(s) and /
Yellow
or not corrected fault(s)
Yellow Disablement(s) in the system.
Steady: Output(s) type "Alarm devices" are disabled.
Flashing: Output(s) type "Alarm devices" have generated
Yellow fault(s).
This is also valid when the FDCIE has no "contact" with a
unit with such an output, e.g. 3379, 4487, etc.
Steady: Output(s) for "ASE" disabled
Flashing: ASE (routing equipment) power supply output
or one or more supervised outputs (of type "Routing
Yellow
equipment" have generated fault(s). This is also valid
when the FDCIE has lost "contact" with a unit with such an
output, e.g. 4461.
One or more of faults not serviced
Output "Fault condition" for fault TX (routing equipment) is
Yellow activated.
Test of routing equipment in progress (see menu H1).
Sensitive fault detection mode is on (see menu H5/A2).
The Alert Annunciation function is enabled.
Yellow
20
Operation Manual
FT1020G3 Rev 2.10.4
10
. See also page 146.
11
via menu (H2/B5).
12
.
14
13