Table of Contents
Advertisement
25.8
Information (H4/U8)
This menu can be used to show the following information for the specific Control Unit you
currently use:
Main board version: The S/W (software / firmware / system program) version downloaded
to the Main board.
MMI board version: The S/W (software / firmware / system program) version downloaded
to the MMI board.
Alarm counter: The alarm counter is increased with "1" every time the FDCIE enters a
real "fire alarm condition" (i.e. fire alarm indication in the display, LEDs "Fire" are
illuminating and the FDCIE buzzer is sounding). Alarms from zones in test mode will not
be counted. The alarm counter starts at 000 and goes to 999. It can be reset to 000 via
EBLWin level 1 access (Control unit menu "Reset alarm counter..."). The value will be
retained also after the FDCIE has been completely powered off. During synchronization,
the alarm counter will also be synchronized, so that the highest value is stored in each
control unit in the system.
Max. number of allowed alarm points that can be used in this Control Unit, i.e. 512 or
1020. (Configured number of alarm points.)
Serial number: The manufacturer's serial number (year YY, week WW, plant P, number
of the main board NNN) used e.g. when upgrading max. no. of allowed alarm points.
Control unit number: 00-29.
Action
"Menu"
Scroll to menu H4.
"↲"
Scroll to menu U8.
"↲"
"ESC"
Text in display
H4 Present system status
U1 Disablement
U2 Disablement by time channel
U3 Open doors
U4 Sensor values
U5 Sensors activating SERVICE signal
U6 Technical warning
U7 Event log
U8 Information
U8 Information
Main board version: 2.10.4
MMI board version: 2.10.4
Alarm counter: nnn
Max number of allowed alarm points: xxx
Serial number: xxxxxxx
Control unit: NN
U7 Information
134
Operation Manual
FT1020G3 Rev 2.10.4
Comments
According to chapter
"Access", see page 42.
Scroll to another menu
or press "ESC".
Advertisement
Table of Contents
