NorthStar 972 Installation Manual page 13

Control head connectors
Control head connectors are shown in Figure 3 on page 9. The control head connects to:
• DC power, through the supplied WA-535 cable with a 7-Amp in-line fuse.
• The processor module, using the supplied WC276-9 DVI video cable and the supplied
WA612-9 data cable.
Table 5: Interface connector functions
Connector name
CONTROL (8-pin
connector)
DATA
(DVI connector)
POWER (3-pin
connector)
Processor connectors
Interface connectors are shown in Figure 4: "Processor connectors," below. The functions of these
connectors are described in Table 6. Interfacing is described in detail in Section Six, beginning on
page 23.
972 Installation Manual, Rev. B
Connector function(s)
Control signals to and from
the processor
Digital video to control head
Power input
FUSE
10 A
PWR
CTRL
Connects to...
CONTROL connector on the
processor module
DATA connector on processor
10 to 32 VDC, 30 watts
DATA
Figure 3: Control head connectors
Page 9