Cme Error Mobile Equipment Error; Colp Connected Line Identification Report; Cr Data Service Report; Creg Network Registration - Nokia 6090 Command Manual

+CME ERROR Mobile Equipment Error

+COLP Connected Line Identification Report

+CR Data service report

+CREG Network Registration

+CRING Distinctive Ring

+CSSI Intermediate Supplementary Service Notification

Nokia 6090 AT Command Set
See details about this command page 25
+CME ERROR: <err>
is given instead of ERROR when +CMEE=1 or =2 and error is related to ME or
network operation.
See also the Error Values section, page 68. (GSM 07.07)
+COLP: <number>,<type>[,<subaddr>,<satype>[,<alpha>]]
is given when +COLP=1 and number received from network when MO call
established.
This intermediate result code is given after (possible) +CSSI result code. Subaddress
and alpha not supported by Nokia 6090. (GSM 07.07) .
See details about this command page 35.
+CR: <type>
is given when +CR=1 and data call established; informs about the type of data call
being established.
This intermediate result code is given after (possible) +COLP result code during MO
data call setup. During MT data call setup this is the first intermediate result code.
Note that this result code shall replace CARRIER result code (when X5 is set). (GSM
07.07).
See details about this command page 42.
+CREG: <stat>[,<lac>,<cid>]
- when +CREG=1:
given when <stat> value changes; given after NO CARRIER if network lost when on-
line
- when +CREG=2:
given when <stat> value changes and when network cell (<lac> and <cid>) of ME
changes; given after NO CARRIER if network lost when on-line; if V.80 is enabled,
result code is sent in-band during on-line data mode (GSM 07.07).
See details about this command page 43.
+CRING: <type>
is given when +CRC=1 and incoming MT call (no active or held calls in ME).
Note that this code replaces the V.25ter RING result code. (GSM 07.07).
See information about +CRC command page 42.
+CSSI: <code1>[,<index>]
is given when +CSSN=1 and some supplementary service notification is given by
network during MO call establishment.
This is the first intermediate result code after dial command D. Supported <code1>'s
depend on the supplementary services implemented in a product. (GSM 07.07).
<code1>:
0
1
Copyright © 2001. Nokia Mobile Phones. All rights reserved.
unconditional call forwarding is active
some of the conditional call forwardings
79