S47 Force Fax Class 2/2.0 Error Correction Mode; T Select Tone Dialling; Define Dce Response Format; Result Code Selection - Nokia 6090 Command Manual

S47 Force Fax Class 2/2.0 Error Correction Mode

T Select Tone Dialling

V Define DCE Response Format
X Result Code Selection

Z Reset to Default Configuration

Nokia 6090 AT Command Set
Error Correction Mode can be enabled using this register. 0=disabled, 1=enabled
with 64 byte frames, 2=enabled with 256 byte frames.
Syntax:
ATS47=<n>
ATS47?
This setting is ignored. It is included for compatibility reasons. (V.25ter)
Syntax:
ATT
This command determines whether result codes are transmitted in a numeric format
or an alphabetic (or verbose) format. (V.25ter)
Syntax:
ATV[0]
ATV1
This command selectively enables or disables the response codes sent to the DTE.
When BUSY, NO ANSWER, DELAYED or BLACKLISTED is not enabled, NO
CARRIER is used instead. When CONNECT <rate> with a correct data <rate> is not
enabled, a plain CONNECT is used instead. This command does not affect the
presentation of other result codes than the ones mentioned below. (V.25ter)
Syntax:
ATX[0]
ATX1
ATX2
ATX3
ATX4
ATX5
This command restores the parameter values of one of the user profiles by recalling
the respective settings from the memory. Settings that are not stored in a profile (see
command &W, page 12) will be reset to their factory defaults (see command &F,
page 11). (V.25ter)
Syntax:
ATZ[0]
ATZ1
Values for <n>: 0..2 (default 0)
Response is <n>. Values for <n>:
000..002
Select numeric (short form) responses.
(Numeric V.25ter basic syntax result
codes with limited headers and trailers.)
Select textual (long) responses. (Verbose
V.25ter basic syntax result codes with full
headers and trailers.) Default option.
OK, CONNECT, RING, NO CARRIER,
ERROR codes enabled.
also CONNECT 1200, CONNECT 2400
enabled.
same as value 1
also BUSY enabled
also NO ANSWER enabled
also CONNECT 4800 (or higher data
rates), CARRIER, DELAYED,
BLACKLISTED enabled. Default option.
Disconnect, reset to stored profile 0.
Disconnect, reset to stored profile 1.
64