Colp Connected Line Identification Presentation; Cops Operator Selection - Nokia 6090 Command Manual

+COLP Connected Line Identification Presentation

+COPS Operator selection

Nokia 6090 AT Command Set
Controls presentation of +COLP intermediate result code or returns COLP
subscription status from network. Nokia 6090 does not support network status query,
<m> equals always 2. (GSM 07.07)
Syntax:
AT+COLP=[<n>]
AT+COLP?
AT+COLP=?
Parameters:
<n >:
0
1
<m >:
2
Set command forces an attempt to select and register the GSM network operator.
<mode> is used to select whether the selection is done automatically by the Nokia
6090 or is forced by this command to operator <oper>, which is given in format
<format>.
Important note: This feature is avaible in 5.300 SW or later.
Syntax:
AT+COPS=[<mode>[,<format>[,<oper>]
]]
AT+COPS?
AT+COLP=?
Parameters:
<mode>:
0
1
<format>:
2
<oper>:
<stat>:
0
1
2
3
Examples:
AT+COPS=1,2,"26202"
Select bearer service type. Default
option is 0.
Query current setting.
Response is +COLP: <n>,<m>
Show supported values.
Response is +COLP: (list of supported
<n>'s).
parameter sets/shows the result code
presentation status in the TA:
disable
enable
parameter shows the subscriber COLP
service status in the network:
unknown (e.g. no network, etc.)
select operator
Query current setting.
Response is +COPS:
<mode>[,<format>,<oper>]
Show supported values.
Response is +COLP: [(list of supported
<stat>), numeric<oper>] [,, (list of
supported <mode>'s), (list of supported
<format>'s)].
network mode, which is choose to select
the network
automatic (<oper> field is ignored)
manual (<oper> shall be presented)
parameter shows the network operator
code:
numeric <oper>
network operator code
Availability of the operator
unknown
available
current
forbidden
35