Add Channels
This function lets you add the Channels that were not
added by "Auto Channel Preset" due to the reception
conditions during the initial setup.
2
Select "Add Channels" using [ K / L ],
then press [ OK ].
• The Password will be required if you have
locked Channels. Refer to 'Channel Lock' on
page 62.
• Channel search will begin.
3
Press [ OK ] on "Finish" to complete
Channel scan.
• Press [
(EXIT) ] to Exit.
Skip Channels
The Channels Selected here will be Skipped when
Selecting the Channels using [ CH +/− ].
Those Channels can still be Selected using [ the
Number buttons ].
2
Select "Skip Channels" using [ K / L ],
then press [ OK ].
3
Select the Channel you would like to
Skip using [ K / L ], then press [ OK ].
• "Watch" this Channel is not Skipped.
• "Skip" this Channel is Skipped.
• To reactivate a Skipped Channel, use [ K/ L ]
then press [ OK ].
• Repeat step
until you Select all the Channels
2
2
you would like to Skip.
• Press [
(EXIT) ] to Exit.
Antenna Out
Set whether you want the Antenna signal to
passthrough when the Power is Off (Standby) mode.
2
Select "Antenna Out" using [ K / L ],
then press [ OK ].
3
Select a desired item using [ K / L ],
then press [ OK ].
This unit will passthrough the
Antenna signal when the Power is
Off (Standby) mode.
On
This unit does not passthrough the
Off
Antenna signal in the Power Off
(Standby) mode.
• If you connect the RF to another device,
recommend to set it "On".
• If you Select "On", Power Consumption is
higher.
Attenuator
To decrease TV Broadcasting signal strength to the
proper level.
2
Select "Attenuator" using [ K / L ],
then press [ OK ].
3
Select a desired item using [ K / L ],
then press [ OK ].
TV Broadcasting signal strength to
the proper level.
On
Maintain the current TV
Off
Broadcasting signal strength.
EN
EN - 61