Channel Settings; Channel - Sanyo FWZH776F Owner's Manual

Channel Settings

Be sure the RF Cable is correctly connected to this
unit and you are Registered with your Cable Digital TV
provider when you install Cable Channels.
1
Press [ HOME ] then Select "Settings"
using [ K / L / 0 / 1 ] then press [ OK ].
2
Select "Channel Settings" using
[ K / L ] then press [ OK ].
3
Select a desired item using [ K / L ]
then press [ OK ].
4
Press [ (EXIT) ] to Exit.

Channel

1
Select "Channel" using [ K / L ], then
press [ OK ].
EN - 60
Auto Channel Preset
If you Switch Input Signal wires (e.g. between DTV
Antenna and DCATV) or if you move the unit to a
different area after the Initial Setting or if you restore the
DTV Channels you Deleted, it is recommended to do
another Auto Channel Preset.
2
Select "Auto Channel Preset" using
[ K / L ], then press [ OK ].
• The Password will be required if you have
locked Channels. Refer to 'Channel Lock' on
page 62.
3
Select a desired item using [ K / L ],
then press [ OK ].
To scan Digital Over-the-Air
Broadcasting.
Antenna
To scan Digital Cable Broadcasting.
Cable
• Channel search will begin.
4
Press [ OK ] to complete Channel scan.
• Press [ (EXIT) ] to Exit.
Note(s)
• After setting "Auto Channel Preset", using
[ CH +/− ] Automatically skips unavailable DTV
Channels/Programs.
• If you are not receiving a signal from your Cable
service, contact the Cable provider.
• If you Select "Back" by pressing [ OK ] during "Auto
Channel Preset", the Setup of TV Channels will be
cancelled.
Continued on next page.