Others - Sanyo FWZH776F Owner's Manual

Subtitle Recording
Record to DVD with Closed Caption or not.
1
Select a desired item using [ K / L ],
then press [ OK ].
Record to DVD with Closed Caption.
On
Off
Record to DVD without Closed Caption.
• Your setting will be activated.

Others

1
Select a desired item using [ K / L ],
then press [ OK ].
2
Set the Selected item in references
below.
Initial Setting
Setting up the unit again. Refer to '3. INITIAL SETUP' on
page 22.
• Make sure that the Antenna Connection was completed.
Standby Settings
This unit boots up at a higher speed in "Normal
Standby" activation, but Power Consumption in Standby
mode will be increased.
1
Select a desired item using [ K / L ],
then press [ OK ].
Normal Standby
In order to make the unit Start faster, then set
to "Normal Standby", then this will increase the
Power Consumption when the Power is Off in
Standby mode.
Energy Saving Standby
"Energy Saving Standby" will reduce the Power
Consumption during Standby rather than "Normal
Standby".
• Your setting will be activated.
Note(s)
• If you Select "Energy Saving Standby", "HDMI CEC" is
automatically set to "Off" and "Network Function" will
be set automatically to "Do Not Use".
EN - 58
Remote Control
Code Select Code Select
Sets the Remote Control Code 1/2/3 on your Remote
Control.
By setting the Remote Control Code to this unit, you can
prevent other devices from responding when you use
the Remote Control.
1
Select your preferred Remote Control
Code using [ K / L ].
2
Keep pressing [ OK ], then press the
Remote Control Code you Selected.
Code Select
Sets the Remote Control Code to 1.
Code1
Sets the Remote Control Code to 2.
Code2
Code3
Sets the Remote Control Code to 3.
Code Alert Code Alert
Set whether you want to Display a message when the
unit is receiving a different Remote Control Code.
1
Select a desired item using [ K / L ],
then press [ OK ].
Code Alert
If this unit receives a different
Remote Control Code, an Error
Message will appear.
On
If this unit receives a different
Off
Remote Control Code, no Message
will not appear.
• If the unit and the Remote Control's Remote
Control Code does not match, an error Display
Message will appear on the Front Panel:
'rc 1' or 'rc 2' or 'rc 3'.
If 'rc 1' is Displayed, you need to change the
Remote Control's Remote Control Code by
simultaneously pressing [ OK ] and press [ 1 ].
If 'rc 2', press [ OK ] and [ 2 ].If 'rc 3', press [ OK ]
and [ 3 ].
Note(s)
• You need to set both the Unit and the Remote
Control to the same Code.
• The Default setting for the Remote Control is
"Code1".
Continued on next page.