Snmp Read Access; Snmp Write Access; Mib-Ii Groups Supported - GE PACSystems RXi User Manual

12.1.3 SNMP Read Access

SNMP provides standard commands that allow a client to read SNMP data. The PNC
supports all of these commands.
■
■
■
The SNMP Community strings supported for read access are:
■
■
■
■
■
These community strings are fixed and cannot be changed.

12.1.4 SNMP Write Access

The RXi Controller does not support SNMP writes.

12.1.5 MIB-II Groups Supported

The PNC supports all of the mandatory values in the following groups of the MIB-II
specification:








The EGP group and Address Translation group of MIB-II are not supported.
The meanings of the values in these groups are well defined by standard literature. However,
the contents of some values are implementation-specific. This section explains contents of
values specific to the PNC.
Interface Number
Many MIB-II groups use an SNMP interface number to refer to a device port. For the RXi
PNC the interface numbers are:
MIB-II Interface Group Values
For the MIB-II Interface Group, the ifDescr value provides a textual description of the
corresponding interface/port. The values returned for that item are the same as the port
numbers listed above.
The counters ifInDiscards and ifInUnknownProtocols are always reported as zero.
GFK-2816F
GET
GETNEXT
GETBULK
public
pub
icmp
private
priv
System group
Interfaces group
IP group
ICMP group
TCP group
UDP group
Transmission group (802.3 Ethernet subset)
SNMP group
Physical Port
External Port #1
External Port #2
Internal Data Port
Chapter 12. PROFINET Network Management
SNMP Interface Number
August 2015
1
2
3
227