Items To Be Checked Before Using This Product; Checking The Product; Devices To Be Furnished By The Customer - Mitsubishi Electric MELFA CR800-D Series Instruction Manual

4. Items to Be Checked Before Using This Product

4.1. Checking the Product

The product you purchased consists of the following items as standard. Please verify that the package
contains all the items.
Table 4.1-1 List of the Standard Items in the Package
No. Note)
Instruction Manual (CD-ROM)
①
CC-Link interface card
②
Ferrite core
③
On-line connector for communication
④
Terminator
⑤
One-touch connector plug for
⑥
communication
Cable clamp
⑦
Cable clamp
⑧
Note) The number of the table is equivalent to the number of following figure.
①
⑤

4.2. Devices to Be Furnished by the Customer

When using Mitsubishi Electric CC-Link interface card, the devices listed in Table 4.2 below must be
furnished by the customer.
Table 4.2-1 Equipment prepared of the customer
Device to be furnished
Master station
Communication cable
*1) For details, refer to "the cc-Link association (http://www.cc-link.org/)."
Name
②
⑥
Figure 4.1-1 Items Contained in the Package
The master station corresponding to the intelligent device station
The cable only for CC-Link
*1）
Performance of the CC-Link system cannot be guaranteed except the
cable only for CC-Link.
The maximum cable total extension and the cable length for the station
have restriction.
Note) If extended cyclic setting is set up more than double, transmission delay time
will become long. Refer to the instruction manual of CC-Link for details.
Type
BFP-A8615
TZ576
E04SR301334
A6CON-LJ5P
A6CON-TR11N
A6CON-L5P
AL5
AL4
③
⑦ ⑧
Condition
13
Quantity
1
1
2
1
1
2
2
2
④
[AL4]
D=6.4mm
[AL5]
D=9.6mm