Change The Advanced Media Settings - Enable The [Low Temperature Mode] - Canon VarioPrint 6000 Series Operation Manual

grade media, you can improve the print quality, with respect to these undesired ghost images, by
changing the value of the [Paper quality] setting to [Low] or even [Lower]. However, this affects
the productivity by almost 5 and 10% respectively.
Please refer to the Troubleshooting chapter for more information (see
page 320).
[Paper quality test]
This test helps you to check if the correct [Paper quality] setting is set. In the Settings Editor, you
can select the media for this test. It is advised to choose the same media as used for the job. Or,
in other cases, choose media which covers the width of the media used as a minimum. When you
start the [Paper quality test], the printer sends 5 empty sheets of the selected media to the system
output. This is done after each of the next 5 black image cleaning procedures. Keep in mind that
this can last 2500, 1250 and 1000 sheets when the [Paper quality] setting is set to [Normal], [Low]
and [Lower] respectively. Then the test stops and the print job continues without interruption.
Check the last set (fifth) of the empty sheets to see if the [Paper quality] setting is cleaning the
print process properly. The sheets should show no pollution.
NOTE
When the system goes into standby mode before the [Paper quality test] has finished, the [Paper
quality test] starts again.
Before you begin
1. On the control panel, touch the [System] button.
2. Touch [Setup].
3. Touch the [Advanced media settings] button in the [Advanced] section.
4. Enter the maintenance PIN when you change a setting.

Change the advanced media settings - Enable the [Low temperature mode]

Procedure
1. Touch the [Low temperature mode] button.
The text on the button changes from [Off] to [On].
NOTE
Each time you touch the button, the setting changes from [On] to [Off] and the other
way round.
2. Press [OK].
When the [Low temperature mode] is [On], this is visible on the dashboard.
VarioPrint 6000 line
Change the advanced media settings - Enable the [Low temperature mode]
NOTE
The control panel will only ask you to enter the maintenance PIN when a
maintenance PIN is defined in the Settings Editor.
Troubleshooting on
Chapter 11 - Media handling 261