Advertisement
Communications (Serial and Parallel)
16.2
Communication Settings
16.2.2
Com. Mode
Select either Normal Mode or Computer Link for performing serial communications.
4.
Communication
41.
Com. Mode
42. RS232C
43. Serial Output
44. Parallel Output
Com. Mode
45. Type Switch Min.
Normal Mode
Computer Link
Normal Mode
This mode is for conventional communication.
Computer Link
With this mode you match the communications protocol to that of a specific PLC
(Panasonic Industrial Devices SUNX Co., Ltd. PLC−FP Series, Mitsubishi PLC−A
Series and FX Series, or Omron PLC−C Series) for inspection data output and reading
the Type No. when switching types.
However, the Normal Mode commands cannot be used (*1) because communication
using parallel signals is required.
Note that, VBTVer.2 can only be used with the Tool port.
Refer to 16.3.1 Serial Command Table.
About Computer Link
Computer Link uses its own special−purpose protocol for communication between the
computer and Image Checker.
Refer to 16.11 Computer Link for details.
16 − 8
Normal Mode
0 ms
OCR Type A230
Advertisement
