Advertisement
OCR Type A230
Save Data
14.1
Save Data
14.1 Save Data
Saves the settings.
If setting data is not saved, any changes made will be lost when the power is turned off.
Procedure for saving data
When checker and other settings are newly changed, a warning message is displayed
at the bottom of the main menu until the data is saved.
The following cases are exceptions to this:
− When making settings using the setting help tools.
− When switching types and "Start Type" is set to No.1.
− When switching types and "Start Type" is set to "Last store type No.", but "Display
message" is set off.
Press ENTER at Save Data, and all the changes made up to that point are saved. There
is no need to save the data every time a change is made, but make sure to save the
data before turning the power off if any settings or changes have been made. The
message shown above is no longer displayed when you save data.
If you select Yes when the above message is being displayed, the data will be saved.
If you select NO or press C, the process will be abandoned.
The following message is displayed when the data save is in progress. Do not use the
keypad, serial or parallel communications, or cut the power while this message is on the
screen.
Doing so may cause not only the loss of the data, but may damage the system or
prevent it from starting up.
The amount of time required to save data depends on the amount of data. A small
amount of data can be saved quickly, but if there is a lot of data, saving may take up
to a minute.
14 − 3
Advertisement
