Mounting The Device With Mounting Brackets - Siemens SIMATIC IPC477D Operating Instructions Manual

Mounting and connecting the device
3.2 Installing the built-in unit
1.
2.
3.
4.
5.
3.2.4

Mounting the device with mounting brackets

If there are strict requirements for the front seal, it may be necessary to fasten the device
with mounting brackets in a cabinet. You can secure each device with 6 mounting brackets.
The mounting brackets are available as accessories. You can find ordering information in the
section Accessories (Page 25).
Requirement
● All packaging components and protective films have been removed from the device.
● The accessory mounting brackets are available.
● 2.5 mm hexagonal spanner
48
Working from the front, insert the device
into the mounting cut-out. Secure the
device to prevent it from falling out.
Insert a mounting clip into the cutout
provided on the device. Make sure it is
in the correct position, see the section
"Mounting clips or mounting brackets,
position for IP65-compliant installation
(Page 45)".
Tighten the threaded pin to secure the
mounting clip. The maximum torque
when tightening the threaded pins of the
mounting clips is 0.5 Nm.
Repeat steps 2 and 3 for all mounting
clips.
Check the fit of the mounting seal.
Mounting clips for devices with 12" display
Mounting clips for 15", 19" or 22" display
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD