Replacing The Ssd (Pro Device) - Siemens SIMATIC IPC477D Operating Instructions Manual

Maintaining and servicing your device
7.4 Installing and removing hardware
7.4.2.2

Replacing the SSD (PRO device)

Requirements
● The device is disconnected from the power supply.
● The device is open, see the section "Opening and closing the backplane cover PRO
device (Page 97)".
● An SSD. The SSD is installed in the backplane cover.
● T10 screwdriver
Procedure
1. Pull out the connectors
Take into account the safety latch of the
cable in doing so.
2. Set the backplane cover down flat.
3. Remove the indicated pan-head screws
and firmly hold down the cover
power supply.
4. Remove the drive cage with the SSD and
power supply and place it with the back
facing up.
5. Remove the indicated countersunk
screws on the back.
6. Remove the SSD.
7. Pull out the SSD connector from the in-
terface.
120
① ② ③
, and .
④
of the
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD