Removing A Pcie Card (Built-In Units With Pcie Card And Dvd Drive); Installing And Removing A Dvd Drive (Built-In Unit Only) - Siemens SIMATIC IPC477D Operating Instructions Manual
Hide thumbs
Also See for SIMATIC IPC477D:
- Operating manual (54 pages) ,
- Operating instructions manual (292 pages) ,
- Quick install manual (2 pages)
Table of Contents
Advertisement
6.4
Removing a PCIe card (built-in units with PCIe card and DVD drive)
The installation and removal of a PCIe card with devices that are expanded with a PCIe card
and with a DVD drive, is the same as the description in the section "Removing a PCIe card
(built-in units with PCIe card without DVD drive) (Page 101)". Access to the PCIe card slot is
covered by the DVD drive, as the following figure shows.
6.5
Installing and removing a DVD drive (built-in unit only)
The following section describes the installation and removal of a DVD drive for devices that
are expanded only with a DVD drive (not with a PCIe card).
Requirements
● The device is disconnected from the power supply.
● The device is removed.
● 1 T10 screwdriver
Procedure
Note
Note the protective measures required when working with ESD in the section "ESD guideline
(Page 133)".
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD
Expanding the device and assigning device parameters
6.4 Removing a PCIe card (built-in units with PCIe card and DVD drive)
103
Advertisement
Table of Contents
