Installing And Removing A Cfast Card (Internal Slot) - Siemens SIMATIC IPC477D Operating Instructions Manual

Expanding the device and assigning device parameters
6.6 Installing and removing a CFast card
1. For built-in unit only: Release the lock of
the cover.
In so doing, press against the cover in
the direction of the arrow. Open the cover
completely.
2. For PRO device only: Remove the indi-
cated screws of the cover.
3. Insert the CFast card into the external
slot as shown in the figure.
Push the CFast card into the slot until it
clicks into place (ballpoint pen mechan-
ics).
4. Close and lock the cover.
Removal
Perform the steps in reverse order.
6.6.2

Installing and removing a CFast card (internal slot)

The procedures for installing and removing the CFast card are the same for all device
variants. Use only SIMATIC IPC CFast cards for industrial application.
Note
Note the following points:
• Use the slot described here exclusively for a CFast card.
• Do not insert CompactFlash cards (CF cards) into the slot for the CFast card.
• Always replace the SIMATIC IPC CFast card with a SIMATIC IPC CFast card of the same
production version or higher. For the SIMATIC IPC477D, only SIMATIC CFast cards with
production version 02 or higher may be used.
The production version can be found on the SIMATIC CFast card, see the section
"Accessories (Page 25)".
Requirements
● The device is disconnected from the power supply.
● The device is open.
● Fir 12" touch built-in unit only:
The SSD is removed, see the section "Replacing SSD (device with 12" display)
(Page 115)".
● SIMATIC IPC A CFast card that is approved for industrial use.
106
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD