Removing A Pcie Card (Built-In Units With Pcie Card Without Dvd Drive) - Siemens SIMATIC IPC477D Operating Instructions Manual

6.3 Removing a PCIe card (built-in units with PCIe card without DVD
drive)
The following section describes the installation and removal of a PCIe card with devices that
are expanded only with a PCIe card (not with DVD drive).
Requirements
● The device is disconnected from the power supply.
● The device is removed.
● 1 PCIe card
● 1 T10 screwdriver
Procedure
Note
Note the protective measures required when working with ESD in the section "ESD guideline
(Page 133)".
Installation
1. Remove the marked screws and take off
the rear panel of the enclosure.
2. Remove the marked screws and pull out
the blanking plate.
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD
Expanding the device and assigning device parameters

6.3 Removing a PCIe card (built-in units with PCIe card without DVD drive)

101