General Bios Setup Settings - Siemens SIMATIC IPC477D Operating Instructions Manual

8.6.5

General BIOS Setup settings

If you have changed any default settings in Setup, you can enter them in the following table.
You can then refer to these entries for any future hardware modifications.
Note
Print out the table below and keep the pages in a safe place once you made your entries.
The default setup settings vary depending on the ordered device configuration.
BIOS Setup settings
Main
System parameters
System Time
System Date
Advanced
System parameters
HPET – HPET Support
Advanced > Boot Configuration
System parameters
Numlock
Advanced > Peripheral Configuration
System parameters
Internal COM 1
Base I/O Address
Interrupt
Internal COM 2
Base I/O Address
Interrupt
PCI - MPI / DP
Profinet
CAN
Base I/O Address
Interrupt
Azalia internal HDMI codec
Onboard Ethernet 1
Onboard Ethernet 2
Depending on the ordered device configuration
1
Only visible if the corresponding parameter "Internal COM#" is enabled.
2
Only visible if "CAN" is enabled.
3
Only available if an Azalia HD audio controller is installed.
4
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD
2
2
1
1 2
1 2
1
1 3
1 3
4
Default settings
00:00:00
MM/DD/YYYY
Default settings
Enabled
Default settings
On
Default settings
Auto
3F8
IRQ4
Auto
2F8
IRQ3
Enabled
Enabled
Auto
5400
IRQ5
Enabled
Enabled
Enabled
Technical information
8.6 BIOS description
Local settings
Local settings
Local settings
Local settings
177