Advertisement
6.
Assemble the retainer of the dust cap onto the
quick-connect fitting
Note:
You will install the cap over the fitting in
Installing the Dust Cap (page
Preparing to Test the
Hydraulic Pressure
Model 31654
Installing the Quick-Connect
Fitting
Machines with the Optional Road Light Kit
1.
At the right side of the traction pump, remove
the 3-pin connector labeled
from the brake-pressure transducer
SENSOR
(Figure
13).
Figure 13
1. Brake-pressure
transducer
2.
Remove the brake-pressure transducer from
the adapter at T-fitting of traction pump port-B
(Figure
14).
(Figure
12).
13).
BRAKE PRESSURE
2. 3-pin connector (labeled
BRAKE PRESSURE SENSOR
1. Adapter fitting
(T-fitting—traction pump
port-B)
3.
Assemble the quick-connect fitting into the
adapter fitting
g344293
1. Adapter fitting
4.
Torque the quick-connect fitting to 27 N∙m (20
ft-lb).
5.
Assemble the test equipment onto the
g344324
quick-connect fitting
)
6
Figure 14
2. Brake-pressure
transducer
(Figure
15).
Figure 15
2. Quick-connect fitting
(Figure
16).
g344291
g344321
Advertisement
