Toro 02820 Installation Instructions Manual

Floating Cutting Unit Kit
3-Plex Mower
Model No. 02820—Serial No. 400000000 and Up
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at
for product safety and operation training materials,
accessory information, help finding a dealer, or to
register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Toro
Distributor or Toro Customer Service and have the
model number of your product ready.
Preparing the Machine
1. Park the machine on a level surface.
2. Lower the cutting units.
© 2022—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
www.Toro.com
Figure 1
Register at www.Toro.com.
This product complies with all relevant European
directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
Contents
Introduction ............................................................... 1
Setup ........................................................................ 1
Preparing the Machine........................................ 1
Preparing the Cutting Units................................. 2
Installing the Kit .................................................. 3
3. Engage the parking brake.
4. Shut off the engine and remove the key from the
ignition switch.
Original Instructions (EN)
Printed in the UK
All Rights Reserved
Form No. 3459-202 Rev A
Installation Instructions
*3459-202*
g196985