Toro 02710 Setup Instructions

32RD Mid-Size Rear-Discharge Deck
Model No. 02710—Serial No. 316000001 and Up
Model No. 02711—Serial No. 316000001 and Up
Model No. 02712—Serial No. 316000001 and Up
These instructions are for a dealer to install a cutting
deck (Models 02710, 02711, or 02712) to a Mid-Size
Power Unit (Models 30069 and 31914).
WARNING
Performing maintenance while the engine is
running can expose your hands, other parts
of your body, and clothing to get caught in
moving parts, causing serious injury.
If you must perform any maintenance while
the engine is running, keep your hands, feet,
clothing, and parts of your body away from
the cutting unit and moving parts.
WARNING
Engine exhaust contains carbon monoxide,
which is an odorless, deadly poison that can
kill you.
Do not run engine indoors or in an enclosed
area.
Important:
Read and understand these assembly
instructions before proceeding. Refer to the Parts
Catalog and Operator's Manual for the machine to
determine which of these parts are to be fitted.
Important:
Ensure that all lifting equipment is
in good condition and has a safe and adequate
capacity. Always seek assistance when lifting
awkward or heavy loads.
Important:
Torque all fasteners to the specified
torque settings. The parts being fitted must not be
drilled, cut or altered in any way.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
These instructions are for dealers only.
Register at www.Toro.com.
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface and engage
the parking brake.
2. Shut off the engine, remove the key, and wait
for the engine to cool.
3. Raise and support the traction unit.
4. Remove the 4 lug nuts securing both wheels to
the traction unit (Figure
Left side shown
Original Instructions (EN) All Rights Reserved *3405-967* B
Form No. 3405-967 Rev B
Setup Instructions
1).
Figure 1
g237244