Brake Pressure Sensor - Toro 02858 Installation Instructions Manual

Note:
Retain the quick-connect fitting.
Figure 28
1. Adapter fitting
3. Assemble the brake-pressure transducer into
the adapter fitting
Figure 29
1. Adapter fitting (1/4 x 7/16
inch)
4. Torque the brake-pressure transducer to 27 N∙m
(20 ft-lb).
5. Plug the 3-pin connector of the machine wire
harness labeled

BRAKE PRESSURE SENSOR

the connector of the pressure transducer
30).
2. Quick-connect fitting
(Figure 29).
2. Brake-pressure
transducer
1. Brake-pressure
transducer
g344321
Installing the Dust Cap
Machines without the Optional Road Light Kit
1. Disconnect the test equipment from the
quick-connect fitting
g344291
into
(Figure
2. Assemble the dust cap over the quick-connect
fitting
11
Figure 30
2. 3-pin connector (labeled
BRAKE PRESSURE SENSOR
(Figure
Figure 31
(Figure 32).
g344324
)
31).
g344293
g344319