Toro 02623 Installation Instructions

Handlebar Extension Kit
HoverPro 450/500/550
Model No. 02623
Safety
The handlebar extension kit provides additional length to the
handlebars, allowing for easier mowing on slopes and similar
terrain.
•
Before using this kit, refer to the HoverPro Operator's
Manual safety section.
•
Use care when maneuvering the machine. The longer
handle may make maneuvering more difficult.
•
Be careful when moving or storing the unit to prevent the
latching mechanism from breaking.
Installation
1. Remove the throttle control from the handlebar. Retain
the mounting fasteners (Figure 1). Loosen the throttle
control cable clamp on the engine, remove the outer
cable from the clamp, and remove the inner cable from
the lever (Figure 3).
2. Remove the 2 handwheels and the 2 U-bolts to
disasemble the HoverPro's upper handlebar from the
lower handlebar. Retain the handwheels and U-bolts.
3. Secure the handlebar extension to the lower handlebar
using 2 handwheels and 2 U-bolts (Figure 1).
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Vibration
Measured vibration level for the left hand = 7.7 m/s
02602); 4.0 m/s
Measured vibration level for the right hand = 6.4 m/s
02602); 5.3 m/s
Uncertainty Value (K) = 3.5 m/s
(model 02604); 3.0 m/s
The vibration levels of model 02602 was measured to
standard EN14910. The vibration levels of models 02604 and
02606 were measured to standard EN836.
Register at www.Toro.com.
2 (model 02604); 6.8 m/s
2
(model 02604); 4.6 m/s
2 (model 02606).
1
5
3
2
Figure 1
1. Throttle control assembly
(1)
2. U-bolt (2)
3. Handwheel (2)
Original Instructions (EN) All Rights Reserved *3371-527* B
Printed in the UK.
Form No. 3371-527 Rev B
Installation Instructions
2
2 (model 02606).
2
2
(model 02606).
2 (model 02602); 2.5 m/s
4
4. Handlebar extension (1)
5. Cable tie (3)
(model
(model
2
g018541