Table of Contents
Advertisement
Changing
Communications
Settings (cont.)
Programming Meter Settings
3. The program now asks for the baud rate. The default rate is
38400
bps.
Note: Although numbers from
rates higher than
a. Press
[ENTER]
to open the drop-down menu.
b. Use the [
] or [
c. Press
[ENTER]
to confirm the entry.
4. The next prompt asks for the parity from five options:
. The default parity is None.
Odd, Mark, Space
a. Press
[ENTER]
to open the drop-down menu.
b. Use the [
] or [
c. Press
[ENTER]
to confirm the entry.
5. The next prompt asks you to select either one or two stop bits. The
default number is 1. Use the [
desired number, and press
6. The final prompt asks you to select either seven or eight data bits.
The default number is 8. Use the [
the desired number, and press
IMPORTANT:
Using RS-232 requires the following parameters:
•
Baud Rate -- the number selected in Step 3 above
•
Parity -- None
•
Stop Bits -- 1
•
Data Bits -- 8
•
To confirm the entries and return to Operate Mode, press
(OK). The CTF878 returns to Operate Mode.
•
To leave the window without confirming the entries, press
[ESC]
(Cancel) or the
key. The CTF878 returns to Operate Mode.
300
115,200
to
are available, baud
38,400
are not recommended.
] arrow keys to scroll to the desired rate.
] arrow keys to scroll to the desired parity.
] and [ ] keys to scroll to the
[ENTER]
.
] and [ ] keys to scroll to
[ENTER]
.
February 2009
None, Even,
[F3]
[F2]
4-9
Advertisement
Table of Contents
