Table of Contents
Advertisement
Entering Analog Inputs
(cont.)
Programming Site Data
a. Press
[ENTER]
to enter the text box. The text creation window
appears, as shown in Figure 1-19 below.
A
B
C
K
L
M
U
V
W
4
5
6
'
=
<
Delete
Figure 1-19: Text Creation Window
b. Use the four arrow keys to scroll to the desired letter or
symbol, and press
Note: Pressing
[SEL]
causes the screen to show successively a set of
upper-case (capital) letters, a set of lower-case letters, and a
set of symbols. Use all three screens to create a desired label.
c. Repeat this procedure for each letter or symbol you wish to add
to the name (up to a total of eight characters). If you wish to
delete a letter, press
from right to left on the label.
d. When you have completed the label, press
[F2]
the label, or
(Cancel) to leave the window without adding
the label.
4. The next three prompts ask for the function units, the zero input
value, and the span input value. For each prompt:
a. Press
[ENTER]
to enter the text box.
b. Use the numeric keys to enter the desired value.
c. Press
[ENTER]
to confirm the entry.
You have completed entering data for general-purpose inputs.
•
To confirm the entries and return to Operate Mode, press
(OK). The CTF878 returns to Operate Mode.
•
To leave the window without confirming the entries, press
[ESC]
(Cancel) or the
key. The CTF878 returns to Operate Mode.
D
E
F
G
H
N
O
P
Q
R
X
Y
Z
0
1
7
8
9
/
>
Cancel
[ENTER]
to add the letter to the name.
[F1]
(Delete) to erase each letter or symbol,
[F3]
February 2009
I
J
S
T
2
3
,
"
OK
(OK) to confirm
[F3]
[F2]
1-19
Advertisement
Table of Contents
