Table of Contents
Advertisement
February 2009
Entering Alarm
Parameters (cont.)
1-26
2. Scroll to the next prompt and select the Data Source measurement
type from a list of choices (see Figure 1-26 below).
a. Press
[ENTER]
to open the window.
b. Scroll to the desired output type.
c. Press
[SEL]
to confirm your selection.
d. The prompt then moves to a list of unit types. (The available
units depend on the selection made at the Data Source prompt.)
Scroll to the desired output unit.
e. Press
[F3]
(OK) to confirm your selection.
Select Measurement
DIAG
Velocity
AuxIn
Pressure
Temperature
Volume
Fwd Totalizer
Rev Totalizer
StdFwd Totalizer
No Unit
Figure 1-26: Data Source Selection Window
3. Scroll to the next prompt and press [
Failsafe
Failsafe
option. If
4. The next prompt asks for the Trigger Point frequency:
a. Press
[ENTER]
to open the text box.
b. Use the numeric keys to enter the desired value.
c. Press
[ENTER]
to confirm your selection.
m/s
Cancel
OK
] to select or deselect the
ENTER
is selected, an
will appear in the box.
X
Programming Site Data
Advertisement
Table of Contents
