Table of Contents
Advertisement
CODE
You cannot be polling receiving.
#0021
#0022
The settings for the One-touch or Coded
Speed dialing buttons you are using to dial the
other party have been deleted.
#0025
During registration of the number for One-
touch or Coded Speed Dialing, you registered
the number for confidential or relay sending
but you omitted the subaddress.
After setting up relay sending or confidential
sending, the settings for One-touch or Coded
Speed dialing may have been changed.
#0033
You have attempted to send a confidential
document to a fax unit that does not support
the use of ITU-T subaddresses.
#0034
You sent a confidential document to another
fax unit but it was rejected.
#0035
You have attempted to relay a document to a
fax unit that does not support the use of ITU-
T subaddresses.
#0036
You have attempted to relay a document to a
fax unit but it was rejected.
#0037
The memory in your fax is full and cannot
store a document for sending or receiving.
#0059
The number you had dialed did not match
with the registered number on the other
party's fax. The number is not registered on
the other party's fax or the number registered
on the other party's fax is not correct.
15-36
Maintenance & Frequently Asked Questions
PROBLEM
SOLUTION
Make sure the subaddress/passwords match
the settings on the other party's fax unit. If the
other party's fax is a Canon fax and can set a
polling ID, request that they set the polling ID
to 255 decimal or 1111 1111 binary.
Correct the One-touch or Coded Speed dial
registration settings. (➞4-6, 4-15)
Open the optional settings for One-touch or
Coded Speed Dialing and make sure that you
have entered a subaddress and password (if
required) for the telephone number. (➞4-8, 4-18)
Open the settings for One-touch or Coded
Speed Dialing and make sure the settings have
not been changed. (➞4-6, 4-15)
Send the document without confidential
settings, or send the document to a fax that
supports the use of ITU-T subaddresses.
Contact the other party and confirm the
settings on the other party's confidential
mailbox.
Send the document by regular transmission.
Contact the other party and confirm that their
relay settings match the relay settings on your
fax unit.
Before you try to clear the memory, you may
want to print a memory list for reference.
(➞8-5)
If there are documents in the memory that you
do not need, erase those documents from the
memory. (➞8-9)
Call the other party and ask the other party to
register the number or to correct the number.
Or, set PHONE NO. CHECK of the system
setting to OFF on your fax. (➞16-31)
Chapter 15
Advertisement
Table of Contents
