Table of Contents
Advertisement
2
Installing the Tow Pole
Parts needed for this procedure:
1
Tow pole kit (sold separately)
Installing the Tow Pole to the Machine
Note: The tow pole is purchased separately and includes the
nut and bolt needed for installation.
The machine has the following tow pole options:
Hitch Type
50 mm (2 inch) ball—stamped
50 mm (2 inch) ball—forged
Pintle
1. Remove the bolt and nut from the tow pole
1
2
G019804
1. Tow pole
2. Front post
3. Bolt
2. Slide the tow pole forward and align the hole in the
pole with the hole in the frame fitting
3. Insert the bolt through the holes in the fitting and the
pole
(Figure
4).
4. Thread the nut onto the bolt and tighten them until
they are tight against the frame fitting
Note: If the self-locking nylon insert in the locknut
wears with use, replace the nut with a new Grade 5 or
Grade 8 locknut.
Length
78.7 cm (31 inches)
78.7 cm (31 inches)
78.7 cm (31 inches)
(Figure
Figure 4
4. Bolt hole
5. Frame fitting
6. Nut
(Figure
(Figure
3
Installing the Safety Chain
Parts needed for this procedure:
1
Safety chain (sold with optional tow pole kit)
2
Connecting link (sold with optional tow pole kit)
Installing the Safety Chain
Note: The safety chain is part of the optional tow pole kit.
1. Form a hook on the end of a bendable piece of rod
or stiff wire (not included), and insert it through both
keyholes in the front post of the machine
A
4).
3
4
C
5
6
1. Keyhole
2. Rod or wire (not included)
2. Attach the safety chain to the length of rod or wire
(Figure
4).
3. Pull the rod, or wire, and the safety chain through both
keyholes
Note: Ensure that approximately equal lengths of
safety chain extend from either side of the front post.
4).
8
B
1
2
3
D
4
3
Figure 5
3. Safety chain
4. Connecting link
5A).
(Figure
5B).
(Figure
5A).
g019883
Advertisement
Table of Contents
