Table of Contents
Advertisement
4. On the side of the junction box for the motor, press
the reset button for the thermal-overload protector
(Figure
25).
5. Connect the electrical plug for the machine to the
power source.
6. Rotate the O
/O
N
FF
ensure that the motor starts normally.
7. Rotate the O
/O
N
FF
Starting and Stopping the
Motor
Starting the Motor
1. Plug the power cord into a proper electrical outlet.
2. Switch the O
/O
N
FF
3. Move the clutch lever to the O
Controlling the Paddles (page 19)
Stopping the Motor
WARNING
In an emergency situation, stop the motor
immediately.
1. Move the clutch lever to the O
Controlling the Paddles (page
2. Switch the O
/O
N
FF
to
Motor O
/O
N
FF
3. Unplug the power cord.
Controlling the Paddles
DANGER
This machine is capable of amputating hands.
• Stay in the operator's position while the machine
is running.
• Keep all bystanders a safe distance from the
machine.
• Stop the machine immediately if any people or
animals enter the work area.
• Never place any part of your body into a position
that causes an unsafe operating condition.
Important: Ensure that the paddles do not turn when
the clutch lever is in the O
Use the clutch lever to control the power transmission to the
paddles of the machine.
switch to the O
position and
N
switch to the O
position.
FF
switch to the O
position.
N
position; refer to
N
position; refer to
FF
19).
switch to the O
position; refer
FF
Switch (page
11).
position.
FF
Using the Clutch Lever
Move the clutch lever clockwise to engage the clutch, and
counterclockwise to disengage the clutch
1
2
1. O
position
FF
Mixing the Material
DANGER
Eye and skin contact with concrete materials and
breathing the dust involved is hazardous to your
health.
• Ensure that there is adequate air ventilation.
• Wear a dust mask to prevent inhalation of dust
while using the machine; refer to
Practices (page
• Avoid direct contact of cement and concrete
materials with skin and eyes.
DANGER
Contact with the mixing paddles could cause
damage or injury.
Never put your hands inside the drum at any time.
Important: Do not add more material than the batch
capacity of the machine; refer to
Note: Follow the manufacturer's instructions that are printed
on the packaging of the product you are using.
19
(Figure
Figure 26
2. O
position
N
Safe Operating
3).
Specifications (page
26).
G019873
11).
Advertisement
Table of Contents
