Table of Contents
Advertisement
Aligning the Adjustable End Paddles
1. Align the adjustable end paddle to the mark that you
made in step
2
of
Aligning the End Paddle Wipers
(page
30).
2. Loosen the carriage bolts and flanged locknuts that
secure the adjustable end paddle to the fixed paddle.
(Figure
48)
Figure 48
1. Carriage bolt and flanged
locknut
2. Closest point of contact
3. Adjust the position of the adjustable end paddle so that
it is as close to the end plate as possible, across the
length of the paddle, without touching end plate when
the paddles are rotated.
4. Torque the carriage bolts and nuts to 37 to 45 N-m
(27 to 33 ft-lb).
5. Repeat the procedure for the adjustable end paddle at
the end plate on the other end of the drum.
3. Drum endplate
Cleaning
Cleaning the Machine
Regular cleaning and washing will increase the life span of
the machine. Clean the machine after each use, before the
dirt hardens.
Ensure that the motor is unplugged.
Use care when using a high-pressure sprayer because it can
damage warning decals, instruction signs, and the motor.
Important: Use pressure sprayers to clean only the
drum of the machine. Clean off the rest of the machine
by hand to keep the motor from getting wet.
Important: Lubricate the trunnions after cleaning; refer
to
Lubricating the Bearings and Seals (page
31
23).
Advertisement
Table of Contents
