Table of Contents
Advertisement
5. Rotate the dump handle clockwise until the drum
latch locks the drum in the upright position
6. After discharging a batch of material, clean the drum;
refer to
Cleaning the Drum (page
Note: This step will clean the paddles and drum
between batches and prevent dried material from
forming, and contaminating the next batch of material.
Cleaning the Drum
Important: Do not strike on the drum with a shovel,
hammer, or any other device to loosen any accumulated
dried materials.
1. Stop the rotation of the paddles by moving the clutch
lever to the O
position; refer to
FF
Paddles (page
19).
2. Move the motor O
refer to
Motor O
N
3. Ensure that the drum is in the mix position (upright);
refer to
Dumping the Drum (page
4. Spray the machine with water to remove any
accumulated material.
5. Start the motor; refer to
6. Start the rotation of the paddles by moving the clutch
lever to the O
position; refer to
N
Paddles (page
19).
7. Dump the drum; refer to
20).
(Figure
21).
Controlling the
/O
switch to the O
N
FF
FF
/O
Switch (page
11).
FF
20), step 5.
Starting the Motor (page
Controlling the
Dumping the Drum (page
28).
position;
19).
21
Advertisement
Table of Contents
