Table of Contents
Advertisement
4. Slip the rear belt over the idler pulley and align the belt
to the rear pulley groove.
5. Slip the forward belt over the motor pulley and align
the belt to the forward pulley groove.
6. Check the belt tension; refer to step 1, step 2, and step
3
in
Adjusting the Belt Tension (page
7. Loosely secure the belt guide to the motor
with the bolt that was removed in step
the Belts (page
26).
8. Adjust the belt guide; refer to
(page
27).
9. Install the divider plate; refer to
Plate (page
23).
Adjusting the Belt Guide
Note: To access the belt guide, remove the divider plate;
refer to
Removing the Divider Plate (page
Guide air gap: 2.5 to 4.0 mm (3/32 to 5/32 inch)
1. Ensure that the clutch lever is in the O
to
Controlling the Paddles (page
2. Ensure that the belt tension is correct; refer to
Adjusting the Belt Tension (page
3. Check that the air gap between the belt guide and the
belts is 2.5 to 4.0 mm (3/32 to 5/32 inch); refer to
Figure
39.
3
2
1
1. Motor pulleys
2. Belts
3. Guide air gap: 2.5 to 4.0
mm (3/32 to 5/32 inch)
4. If the air gap is not within the specified range, do the
following:
A. Loosen the nut that secures the belt guide to the
motor
(Figure
Important: Ensure that the belt guide is
toward the motor pulley.
25).
(Figure
3
of
Removing
Adjusting the Belt Guide
Installing the Divider
22).
position; refer
N
19).
25).
5
4
G020666
Figure 39
4. Belt guide
5. Nut
39).
B. Rotate the belt guide up or down until there is
an air gap of 2.5 to 4.0 mm (3/32 to 5/32 inch)
between the guide and each belt
Important: The belt guide should not
contact the belts with the clutch lever in the
O
position.
N
37)
Note: If the air gap between the belt guide and
both belts cannot be attained, then 1 of the belts
is too long.
C. Tighten the nut that secures the belt guide to the
motor
D. Check the clutch operation; refer to
Clutch Operation (page
5. Install the divider plate; refer to
Plate (page
Checking the Clutch Operation
Service Interval: Every 40 hours—Check the clutch
Important: The paddles must not rotate in an empty
drum when the clutch lever is in the O
1. Move the clutch lever to the O
Controlling the Paddles (page
2. Start the motor; refer to
3. If the paddles rotate with the clutch lever to the O
position do the following:
A. Stop the motor; refer to
(page
B. Check the air gap between the belt guide and the
belts.
Note: If the air gap is larger than 4.0 mm (5/32
inch), decrease the gap between the belt guide
and the belts; refer to
(page
4. Repeat steps 1, 2, and
are met:
•
The clutch lever is in the O
•
While the motor is running, the paddles do not
rotate in an empty drum.
27
(Figure
39).
27).
Installing the Divider
23).
operation.
FF
position; refer to
FF
19).
Starting the Motor (page
Stopping the Motor
19).
Adjusting the Belt Guide
27).
3
until the following conditions
position.
FF
(Figure
39).
Checking the
position.
19).
FF
Advertisement
Table of Contents
