Installing the Divider Plate
1. Guide the divider plate into position against the front
cowl.
Note: Start with the divider plate rotated slightly
counterclockwise, and then rotate it clockwise while
lowering it into position.
Ensure that the divider plate is not backward.
Figure 30
2. Align the bolt holes in the divider plate and the front
cowl.
3. Install each of the 4 bolts, and hand-tighten them to
prevent cross-threading.
4. Tighten the bolts with a wrench until they are secure.
Lubrication
Lubricating the Bearings and
Seals
Service Interval: After each use—Lubricate the trunnions.
Monthly—Lubricate the pillow-block bearings.
Note: The pillow-block bearings are inside the
cowl—remove the divider plate to access them; refer to
Removing the Divider Plate (page
Grease type: #2 general-purpose lithium-based grease.
1. Clean around each grease fitting with a rag and lift the
plastic cap off the grease fitting
1
G021586
1
2
1. Pillow-block bearings
2. Rear trunnion
23
22).
(Figure
31).
2
3
3
Figure 31
3. Front trunnion
g021 101